how to install retropie with applepi baker

This is what I did from the very beginning to get a full functional station:Ģ.- Mount image on the microSD card using ApplePi-Baker (.ģ.- Use 'raspi-config' command to set up keyboard layout and expand file system.Ĥ.- Update rasberry firmware with 'sudo rpi-update'ĥ.- Install Gamescon driver with corresponding option in 'retropie_setup.sh'Ħ.- Mount db9_gpio_rpi driver with 'modprobe -first-time db9_gpio_rpi map=4,4'. Note: This worked for me right away, but if not you may want to try the earlier OS version, see notes on the OpenElec Wiki page.I am far from being an expert in Linux based systems so all achievements in software were made by reading and asking over the internet. Your Apple TV will now factory restore to OS v 3.0.2.When completed, remove power, remove USB stick, power up and hold down the 'menu' and ' - ' keys simulatenously, this will bring your Apple TV into Recovery mode.

Your Apple TV will now boot up from the USB stick and will install the latest OS on its harddrive.

Unpower your Apple TV, plug in the USB stick, power up your Apple TV.

Using the ApplePi-Baker, or the other methods, restore the disk image to the USB stick be patient, this may take a while.

If you're not on a Mac, follow the instructions in the thread posted in 1.

If you're on a Mac, download and install the ApplePi-Baker application from here:.

I downloaded the Apple OS v3.0.2 file, this proved to be working.

download the disk image with the Apple OS from here:.

however the second method described (no network needed) worked, but not with the file posted on the website (had wrong size).

the first method described didn't work for me, is time consuming, and you need an ethernet internet connection.

you need a good size USB stick, mine was 4GB.

for reference, have a look at this webpage, but keep reading below: g-disk/.

My trusted Apple TV first generation had mysteriously turned itself into a brick.Īfter searching the web and trying all kinds of things, I figured out how to save it. I tried this several times but always the same result.

Factory Restore immediately brought up a failure message that factory restore was not possible!.

Diagnostics showed my Apple TV to be working normally.

Restart from there didn't work, only resulted in coming back to the recovery menu.

On the discussions here ( Re: Apple TV 1st gen Factory Restore Problems ) I found out how to force restart by holding down the 'menu' key and the ' - ' key simultaneously. My intital attempts to just remove power and startup again failed and resulted in repeated crashes and renewed startups. The other day, while watching a movie, my Apple TV 1st gen just froze and became unresponsive to any remote control inputs.

How to install retropie with applepi baker